Fault Finding - Prem-I-Air EH1220 Instructions Manual

Compressor dehumidifier
Hide thumbs Also See for EH1220:
Table of Contents

Advertisement

Available languages

Available languages

• If the mains lead is damaged, it must be replaced by the manufacturer
or an authorised service centre. If the mains plug needs to be replaced,
proceed as follows:
Earth
(Green
Yellow)
Neutral
(Blue)
• If the plug is fitted with a 13 A fuse, replace it by a 5 A fuse.
Appliance does not operate when switched on:
• There is a 3 minute delay before the compressor starts. This is to
protect the compressor.
Appliance stops operating and "FULL" indicator lights.
• Bucket is full of water - empty the water as shown on page 6. Do not
drink the water (it may be used for watering plants).
• Bucket is not replaced properly. Ensure that the bucket is correctly
aligned with the housing.
Very little water is extracted.
• There is very little humidity in the air (this happens during dry sunny
weather, and also during very cold weather). Condensation on windows is
caused by the difference between indoor and outdoor temperatures, and
is not a good indicator of the level of humidity.
The room remains humid and little water is extracted
• The area to be dehumidified is too large
At time of going to press, the average cost of electricity is £0.12 per unit
(kilowatt-hour). The amount you are being charged will be shown on your
electricity bill.
At this cost, the appliance will cost £0.04 per hour to run on the
"continuous" setting.
• Connect the brown wire to the terminal labelled
Fuse
(5A)
"L".
• Connect the blue wire to the terminal labelled
"N".
• Connect the green/yellow wire to the terminal
labelled with the earth symbol or "E".
• Make sure that the cord-grip is positioned
Live
correctly (over the outer sheath of the cable) and
(Brown)
it fully tightened.

FAULT FINDING

OPERATING COSTS
Page 6

Advertisement

Table of Contents
loading

Table of Contents