Assigning The Vbus ® Address; Microsd Card; Energy Saving Mode; Firmware Update - Resol VBus/EnOcean Interface adapter Manual

5.2 Assigning the VBus address
®
In the basic setting, the interface adapter has the VBus
has to be registered in the controller using the number it has been assigned as the
VBus address.
®
After it has been successfully linked with the controller, the functions of the EnO-
cean device will be available on the controller. Please pay attention to the control-
ler manual!
If several interface adapters are used, each one has to be assigned with its own
VBus ® address.
In order to assign a VBus address (A1 - A5) to the interface adapter, proceed as
®
follows:
Î In order to select a VBus address, briefly press the set button until (A1 - A5)
®
is indicated.
Î To change the VBus address, press the set button for 5 s.
®
The display starts flashing.
Î Release the button. [ ] is indicated.
6

MicroSD card

The interface adapter is equipped with a MicroSD card slot for MicroSD memory
cards.
Save adjustments
Î In order to save the adjustments on the MicroSD card, select the menu item
St and press the set button for 10 s until the indication flashes.
The adjustments are stored as a SET file on the MicroSD card.
Load adjustments
Î In order to load the adjustments from the MicroSD card, select the menu item
SL and press the set button for 10 s until the indication flashes.
7

Energy saving mode

In the energy saving mode, the 7-segment display is switched off. After 4 min. the
display switches to the energy saving mode. The energy saving mode is interrupted
if the set button is pushed, a MicroSD card inserted or if an error occurs.
20
8
address 1. The interface
®
The current software can be downloaded from www.resol.de/firmware (VB_
ENxxx.RSF).
Î Create a folder named RESOL\VBus\Enocean on the MicroSD card and ext-
ract the downloaded ZIP file into this folder.
When a MicroSD card with a firmware update is inserted, Sd is indicated for 30 s.
Î In order to perform an update, press the button for 3 s while Sd is indicated.
During the update process, the LED is red / green. The progress is indicated in per-
cent. When the update has been completed, [ ] is indicated.
9
The VBus
the power supply connection. The bicoloured LED indicates the operating state of
the interface adapter:
Colour
Green
Red
Red/green Firmware update in progress
Off
10
If a MicroSD card is used, all information on teach-in processes, and errors regar-
ding channels, VBus
bers in a protocol in CSV format.

Firmware update

Note:
The device will only recognise a firmware update file if it is stored in a
folder named RESOL\VBus\Enocean on the MicroSD card.

Operating control LED

/ EnOcean interface adapter is equipped with a bicoloured LED near
®
Permanent
Normal operation
VBus ® and EnOcean error
No supply voltage available

Protocol

, MicroSD card and updates is logged with consecutive num-
®
Flashing Flashing quickly
Teach-in process -
in progress
- EnOcean error
- -