Hdmi Connector Cn501 - HP 32s Maintenance And Service Manual

• After repaired, must connect source to each port to check Main board function is ordinary.
Note: (The requirement of professional repairers' regulation by ERP lot5)
1) The professional repairer has the technical competence to repair electronic displays and complies
with the applicable regulations for repairers of electrical equipment in the Member States where it
operates. Reference to an official registration system as professional repairer, where such system exists
in the Member States concerned, shall be accepted as proof of compliance with this point.
2) The professional repairer is covered by insurance covering liabilities resulting from its activity,
regardless of whether this is required by the Member State.

HDMI connector CN501

Repair the HDMI connector:
1. Use a soldering iron and a desoldering pump to remove as much solder as possible from the
pin.
2. Use a hot air gun to melt the solder on the pins.
3. Lift the CN501 connector from the PCB.
4. Place the new component on the PCB. Be sure that it matches the PCB footprint.
5. Solder the new component.
17