Operation; Turntable Playback; Aux In Playback; Listening To Fm Radio - ION Digital LP Quick Start Manual

Operation

Turntable Playback

Before use, please make sure to:
•
Remove the stylus protector. Reconnect the protective cap on the stylus when not in use.
•
Ensure the tonearm is free to move from the tonearm rest. Lock the tonearm in place again when not
in use.
1. Set the Mode to Phono and lift the turntable dust cover.
2. Place a record on the turntable, over the central spindle on the slipmat.
3. Set the Speed selector to 33, 45, or 78 rpm depending on the record.
4. Lift the tonearm from the tonearm rest and slowly move it over the record. The turntable platter will
start turning.
5. Place the tonearm on the desired location of the record.
6. Gently lower the tonearm onto the record to start playing.
7. When the record is finished playing, the tonearm will automatically stop. Lift the tonearm from the
record and put it back on the rest.
8. To manually stop the record, lift the tonearm from the record and return it to the rest.
Note: Do not stop or turn the platter manually. Moving or jarring the turntable without securing the
tonearm clamp could result in damage to the tonearm.
Auto-stop Switch Operation
Certain types of records may have an auto-stop area outside the pre-set limit, so the turntable may stop
before the last track finishes. If this occurs, set the Auto-stop switch to the Off position. This allows the
record to play to the end, but it will not stop automatically. You must manually raise the tonearm and place
it back in the rest and then turn the power off to stop the turntable from spinning.

Aux In Playback

1. Press the Mode button to select Aux In.
2. Connect an 1/8" (3.5 mm) stereo audio cable (not included) from the Aux In to the line output or
headphone output of your external audio device to be able to listen to the external source through
Digital LP's internal speakers.
3. Adjust the volume on Digital LP to the desired level.
Note: If the line output of your external device is connected, you only need to adjust the system's volume
control. If your external device's headphone output is connected, you may need to adjust the volume
control on both your external device and Digital LP to achieve the desired volume.

Listening to FM Radio

1. Press the Mode button repeatedly to cycle though and select the FM radio.
Select the FM radio station using the ▲▼ buttons.
2.
3. Adjust the Volume knob to the desired level.
DAB Station Scanning
DAB (Digital Audio Broadcasting) broadcasts radio via a network of transmitters. This provides listeners with
more broadcast selections (where available) and clear sound quality.
1. Press the Mode button repeatedly to cycle through and select DAB.
Use the ▲▼ buttons to select Station Scan and press Enter.
2.
3. Select from the following scanning options using the▲▼ buttons.
•
Local Scan: The unit will scan local DAB bands between 10A and 13F to look for broadcasts.
•
Full Scan: The unit will scan all DAB bands to look for broadcasts.
•
Manual Tune: Select the desired specific frequency band to look for a broadcast.
4. Press Enter to select the desired option.
Note: The signal strength indicator will be shown on the display.
7