Setting The Alarm; Menu Options - ION Digital LP Quick Start Manual

Setting the Alarm

1. Press the Alarm button.
Use the ▲▼ buttons to select the Mode (DAB or Buzzer), Alarm, Alarm Time, and Volume. Press
2.
Enter to confirm the selection.
3. Adjust the settings using the Up/Down buttons and press Enter to confirm the settings.
4. Select the Save option and press Enter to store the changes.

Menu Options

Press and hold Menu/Info in each of the modes to adjust the following options:
Phono and Aux In modes
Time Setup: set the clock time, date, auto update, and time display (12 hour or 24 hour time)
Factory Reset: Select to reset the unit back to factory default settings.
SW Version: Select to view the current software version.
FM mode
Audio Setting: Select the audio output to be stereo or mono, or mono only for radio stations.
DAB mode
Station Scanning: Scans for available DAB stations
Using Digital LP With Your Computer
Recording
To record music to your computer, you can use ION EZ
Vinyl/Tape Converter and a USB cable. EZ Vinyl/Tape
Converter conveniently saves your recordings to your
computer. After you finish converting your vinyl, you can then
burn to CD or load onto portable media devices.
Follow the instructions on the included software download
card for installing EZ Vinyl/Tape Converter.
1. With EZ Vinyl/Tape Converter installed on your computer, use a USB cable to connect Digital LP's USB
port to an available USB port on your computer.
2. On your computer, you can open EZ Vinyl/Tape Converter by going to Start Menu  All Programs
(Windows) or the Applications menu (Mac).
3. Follow the on-screen instructions to set up your recording. When prompted to play your music, move
Digital LP's tonearm over the record to start playback.
Note: To listen to a record while it's playing, listen through your computer's speakers, or connect Digital
LP's RCA outputs to a stereo system or powered speakers. Do not connect them to phono-level inputs;
Digital LP's RCA outputs are line-level and could damage a device with phono-level inputs.
4. When you have finished recording, raise Digital LP's tonearm from the record and return it to its arm
clip.
Tip: If the program is not recognizing audio from Digital LP, try turning the volume knob on Digital LP clock-
wise.
Visit ionaudio.com/computer-optimization
8
for more information on optimizing your computer for audio.
Visit ionaudio.com/ezvc
the latest version of EZ Vinyl/Tape
Converter software or for helpful
troubleshooting guide and additional
support.
to download