Operation - ION PRO200BT Quick Start Manual

Operation

Pairing Pro200BT to a Bluetooth Speaker
Pro200BT has a Bluetooth transmitter to send audio to a Bluetooth speaker wirelessly.
1. Power on your Bluetooth speaker and ensure it is in pairing mode.
2. Power on the Pro200BT turntable. Wait five seconds for it to be ready for Bluetooth
Pairing.
3. Press and release the Bluetooth Button on Pro200BT to start pairing to your Bluetooth
device. Once Pro200BT is connected to the Bluetooth speaker, the Bluetooth LED will be
solid blue. Your Bluetooth speaker should also indicate that its paired.
Note: Pro200BT will connect to the closest Bluetooth speaker that is near it. If after 5
minutes no Bluetooth speaker can be found to pair with, the Bluetooth transmitter will
become inactive and the LED will turn off.
Note: Maximum range will be achieved when using devices with Bluetooth 4.0 or higher.
4. Play music on your Pro200BT turntable. If you are connected to a Bluetooth speaker with a
play/pause button, and do not hear audio, try pressing the play/pause button.
5. Adjust the volume on your Bluetooth speaker (if applicable) or the Volume Knob on
Pro200BT to control the output level.
6. To disconnect pairing, power off the Pro200BT turntable, turn off Bluetooth pairing on your
Bluetooth speaker, or press the Bluetooth Button on the Pro200BT.
Note: Move other Bluetooth receivers/speakers out of range of Pro200BT (30'/9.1m or more)
or turn them off when connecting to your Bluetooth speaker.
Playing a Record
1. Connect the included power adapter to Pro200BT and use the Power Button to power on
Pro200BT.
2. Remove the needle cover from the cartridge.
3. Place the slipmat on the platter and then place a record on the slipmat. If using 45 RPM
records, put the 45 RPM adapter on the center spindle before placing the record on the
platter.
4. Use the 33/45 RPM Selector to set the platter rotation speed (33/45) to match the type of
record.
5. Set the 7"/12" switch to match the record size that you have on the platter.
6. Press the Start button to have the unit automatically place the tonearm.
7. When the record reaches the end or if Stop is pressed during playback, the tonearm will
automatically lift and return to the resting position.
6