Selecting The Image Display Mode; Selecting The Display Size; Displaying The Grid Lines - Canon EOS 10D Instruction Manual

Selecting the Image Display Mode

You can change the size and method in which images are displayed.

Selecting the Display Size

You can select the image size from [Fit to window] (Fitting to the image display area), [50%
view], [100% view] (actual pixel size), and [200% view].
Select [View] menu Select the size to be set.
The image is displayed in the selected size.
When you display an image in a larger size, you can change the display position by
dragging the image.
In the [Fit to window] display, if you double-click a section you want to enlarge, the display
changes to the [100% view] display. If you double-click on the image in the [50% view],
[100% view] or [200% view] display, the display changes to the [Fit to window] display.

Displaying the Grid Lines

You can display grid lines that allow you to check the horizontal or vertical level of the image.
Select [View] menu [Grid lines].
Grid lines are displayed on the image.
Performing the same operation again hides the grid lines.
You can specify the grid spacing (p.1-20).
Displaying the Edited Image and the Original at the Same Time
You can display the edited image and the original at the same time.
Select [View] menu [Before/after comparison].
A split window with the image before and after editing is displayed.
The way the image is displayed can be changed (p.1-20).
Changing the Display Position
You can also tile images vertically.
Select [View] menu [Change up/down/left/right].
Performing the same operation again tiles images horizontally.
Editing RAW Images
You can perform more detailed edits on RAW images that are supported by Digital Photo
Professional, than in the main window. With RAW image editing (p.2-3 to p.2-6), there is hardly
any of the deterioration which accompanies image editing. You can therefore edit an image
multiple times while preserving the image quality at the time the image was shot.
Display the RAW image in the edit window
1
When multiple images are displayed, click the image for which you wish to edit to
place it in the top window.
Select the [RAW image adjustment] tab on the tool palette.
2
The [RAW image adjustment] tab
sheet appears.
Edit the RAW images
3 (p.2-3 to p.2-6)
You can apply edits to other images by copying and pasting the edit data to the other
images (p.1-13).
You can revert edited images to the last saved settings or shot settings (p.1-14).
Compare the edited image with the original
4
Save the edited image .
5 (p.1-14)
You cannot edit PowerShot Pro1 RAW images.
Before quitting Digital Photo Professional, you must save the edited images (p.1-14).
The editing data can be saved in a separate file (p.1-13).
Adjusting the Brightness
You can adjust the brightness in the range of –2.0 to +2.0 (in 0.01-stop increments when
entering a value).
Adjust an image while viewing it.
Drag the slider left or right to adjust the brightness.
.
(p.2-2)
.
.
(see left)
Restores the image to its original settings.
Enter a value to adjust the brightness.
Cover/Table of
Contents
Introduction
Displaying Thumbnail Images 1
and Performing Basic Edits
in the Main Window
2
Performing Detailed
Edits in the Edit
Window
3
Performing Detailed
Edits in the Edit
Image Window
Displaying an 4
Image in the Quick
Check Window
5
Reference
Index
2-3