Canon Ultura Instruction Manual page 9

Charging and attaching the battery pack
2
Your battery pack was partially charged before it left the factory. It should have
enough power for you to check that your camera is working properly. However,
you must charge the battery pack fully if you want it to power the camera for
more than a few minutes.
1. Set the POWER switch to OFF before you charge the battery pack.
2. Connect the power adapter to the camera.
3. Open the battery cover and insert the battery into the camera.
• Insert the battery in the direction of the arrow until it clicks into place, then
close the battery cover.
4. Plug the adapter into an AC outlet.
• The charge indicator flashes red to show that charging is in progress. Single
flashes mean that the battery pack is less than 50% charged. Double flashes
mean that it is between 50% and 75% charged. Triple flashes mean that it is
more than 75% charged. The indicator glows steadily when the battery pack
is fully charged.
• Charging will also take place when the camera is in stop mode during VCR
mode, or the power is off in camera mode. This charging will take longer
than when the POWER switch is set to OFF.
5. When charging is complete, disconnect the power adapter.
6. Remove the battery pack after use.
• Place the camera on its side before removing the battery pack, since the
battery pack may drop out when you press the battery release button.
• Press the battery release button to the left.
• Always turn the camera off before removing the power source.
Note:
• You can find detailed notes for using the batteries in the "Notes on Using the
Batteries" on p. 75. These notes include charging and recording times and how
to install the backup battery.
3
4
E
6
9