Canon FS10 Instruction Manual page 89

READING THE CARD
- Reading data from the memory card.
SOME SCENES COULD NOT BE DELETED
- Movies that were protected/edited with other devices cannot be deleted.
TASK IN PROGRESS DO NOT DISCONNECT THE POWER SOURCE
- The camcorder is updating the memory. Do not disconnect the compact power adapter or remove the battery
pack.
THE CAMCORDER IS SET TO STILL IMAGE MODE
- You pressed Start/Stop
THE CARD IS SET FOR ERASURE PREVENTION
- The LOCK switch on the SD or SDHC memory card is set to prevent accidental erasure. Change the position of
the LOCK switch.
THE MEMORY CARD COVER IS OPEN
- After inserting a memory card, close the memory card slot cover (
TOO MANY STILL IMAGES DISCONNECT USB CABLE
- Disconnect the USB cable and decrease the number of still images on the memory card to fewer than 1,800.
If a dialog appeared on the computer screen, close it and then reconnect the USB cable.
TRANSFER ORDER ERROR
- You attempted to set more than 998 transfer orders. Reduce the number of still images marked with transfer
orders.
UNABLE TO RECOGNIZE THE DATA
- You transferred data to the camcorder recorded in a different television system (PAL or SECAM).
- A memory card with data recorded in a different television system (PAL or SECAM) was inserted into the
camcorder.
UNABLE TO RECOVER DATA
- Could not recover a corrupted file.
WHILE THE CAMCORDER IS CONNECTED TO A PC DO NOT DISCONNECT THE USB CABLE OR POWER SOURCE
CANNOT TURN OFF POWER OR CHANGE MODES
- When the camcorder is in
cannot be operated. Disconnecting the USB cable or power source while this message appears may result in
permanent loss of the recordings in the camcorder. Use the computer's Safely Remove Hardware function to
end the connection and disconnect the USB cable before using the camcorder.
Messages Related to the Optional DW-100 DVD Burner
If a message appears while the camcorder is connected to the optional DW-100 DVD
Burner, refer to the following section and also to the instruction manual of the DVD
Burner.
CANNOT READ THE DISC CHECK THE DISC
- During disc recording mode, this message can appear when a commercially available DVD disc (a DVD disc
containing movies, software, etc.) or an 8 cm mini DVD disc is inserted.
while recording still images (
mode and is connected to the computer with a USB cable, the camcorder
mode).
29).
89