Canon FS10 Instruction Manual page 21

1
Press the tab in the direction of
the arrow and pull out the battery
holder.
2
Place the lithium button battery
with the + side facing up.
3
Insert the battery holder.
T
O USE THE WIRELESS CONTROLLER
Point the wireless controller at the
camcorder's remote sensor when
you press the buttons.
You can rotate the LCD panel 180
degrees to use the wireless controller
from the front of the camcorder.
NOTES
• The wireless controller may not work
properly when the remote sensor is
situated under strong light sources or
direct sunlight.
• If the wireless controller does not work,
check that [WL.REMOTE] is not set to
[ OFF ] ( 80). Otherwise,
replace the battery.
Accessories
Fasten the grip belt.
• Adjust the grip belt so that you can
reach the zoom lever with your index
finger, and the Start/Stop
your thumb.
• You can remove the grip belt and
replace it with the supplied wrist
strap.
T
O REMOVE THE GRIP BELT
1 Lift the padded handgrip's flap
and detach the strap from the
Velcro pad.
2 Pull the strap to remove it first
from the front bracket on the
camcorder, then to unthread it
from the handgrip and finally to
remove it from the rear bracket on
the camcorder.
button with
21