Declaration Of Conformity - Cambridge SoundWorks DTT2500 Installation And Operating Instructions Manual

Safety & Regulatory Information
The following sections contain notices for various countries:
Notice for the USA
All cables used to connect the computer and peripherals
must be shielded and grounded. Operation with non-
FCC Part 15: This equipment has been tested and certified computers or non- shielded cables may result in
found to comply with the limits for a Class B digital
interference to radio or television reception.
device, pursuant to Part 15 of the FCC Rules. These
Modifications
limits are designed to provide reasonable protection
against harmful interference in a residential Any changes or modifications not expressly approved
installation. This equipment generates, uses, and can by the grantee of this device could void the user's
radiate radio frequency energy and, if not installed authority to operate the device.
and used in accordance with the instructions, may
Notice for Canada
cause harmful interference to radio communications.
However, this notice is not a guarantee that
This apparatus complies with the Class B limits for
interference will not occur in a particular
radio interference as specified in the Canadian
installation. If this equipment does cause harmful
Department of Communications Radio Interference
interference to radio or television reception, which
Regulations.
can be determined by turning the equipment off and
Cet appareil est conforme aux normes de CLASSE "B"
on, the user is encouraged to try one or more of the
d'interference radio tel que spe'cifie' par le Ministère
following measures:
Canadien des Communications dans les règlements
• Reorient or relocate the receiving antenna.
d'interfèrence radio.
• Increase the distance between the equipment
and receiver.
• Connect the equipment to an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/ TV technician.
CAUTION: To comply with the limits for the Class
B digital device, pursuant to Part 15 of the FCC
Rules, this device must be installed with computer
equipment certified to comply with the Class B
limits.
Compliance

Declaration of Conformity

This product conforms to the following Council Directive:
According to the FCC96 208 and ET95-19
• Directive 89/ 336/ EEC, 92/ 31/ EEC (EMC),
Name: Creative Labs Inc.
73/23/EEC (LVD)
Address: 1901 McCarthy Boulevard
Milpitas, CA. 95035
United States
Tel: (408) 428-6600
declares under its sole responsibility that the product
Trade Name: Creative Labs/
Cambridge SoundWorks
Model Number: CSW3500
has been tested according to the FCC / CISPR22/85
requirement for Class B devices and found compliant
with the following standards:
EMI/ EMC: ANSI C63.4 1992, FCC Part 15 Subpart B
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference,
and
2. This device must accept any interference received,
including interference that may cause undesirable
WARNING: To prevent fire
operation.
or shock hazard, do not
Ce matériel est conforme à la section 15 des régles
expose this appliance to
FCC. Son fonctionnement est soumis aux deux
rain or moisture.
conditions suivantes:
1. Le matériel ne peut étre source d'interférences et
2. Doit accepter toutes les interférences reques, Y
Important Notice
compris celles pouvant provoquer un
fonctionnement indésirable.
The serial number for the DTT2500 Digital is
located on the Decoder Amplifier. Please write this
Compliance Manager
number down and keep it in a secure area. This is for
Creative Labs, Inc.
your security.
March 4, 1999
i