Examine the speaker system carefully for shipping damage. If there is any, do not install or use the sys- tem. Return the speaker to the store where you made the purchase or call Cambridge SoundWorks at 1-800 FOR-HIFI (1-800-367-4434) for assistance.
POSITIONING YOUR SPEAKERS SPEAKERS ARE LABELED "LEFT" OR "RIGHT" The following suggestions assume you have some flexibility regarding where you place your speakers. Don’t be too concerned if your situation and listening environment dictate the speakers’ position. As long S200 Multipole“...
Hang the S200 or S300 directly on a wall: Install a No.10 screw in the wall so that its screwhead protrudes about 3/8 inch. Cambridge SoundWorks supplies screws and plastic anchors for your conven- ience, but it is the installer’s responsibility to insure the screw is securely mounted.
Page 6
Apply the feet to the surface of the speaker opposite the MultiPole switch, in the pattern shown. Using The Speakers On A Stand Cambridge SoundWorks has floor-stands available for the S200 and S300. APPLY SELF-ADHESIVE FEET TO BACK OF SPEAKERS.
Page 7
About MultiPole Technology MultiPole Modes The MultiPole capability of your S200 and S300 lets you better enjoy different types of surround programs at their best. The descriptions that follow assume you will position your surround speakers to the left and right of the listening area and not directly behind it.
PREPARE THE SPEAKER WIRE Use at least 18 gauge speaker cable for short runs Strip off 1/2" (under 15 feet). Use 16 gauge or heavier speaker cable for longer runs. 1. Determine how long the speaker cable should be for each speaker. Cut the speaker cable into the appropriate lengths.
Distortion dramatically increases the internal operating temperature of a loudspeaker and will even- tually cause the speaker’s failure due to burned or melted internal parts. While Cambridge SoundWorks includes the most heat-tolerant parts commensurate with good acoustic design, the speaker’s Limited...