Summary of Contents for Cambridge SoundWorks DTT2200
Page 2
PLUS LARGE DE LA FICHE DANS LA BORNE IMPORTANT NOTICE (EMC), 73/ 23/ EEC CORRESPONDANTE DE LA PRISE ET The serial number for your DTT2200 is located on the (LVD) POUSSER JUSQU’AU FOND. subwoofer. Please write this number down and keep it in a...
Page 3
Cambridge product due to lightning and power-line parts specified by Cambridge SoundWorks should be adhered to. SoundWorks’ instructions have been surges. or have the same characteristics as the FOLLOW INSTRUCTIONS –...
Page 4
EAX , DirectSound 3D, Dolby Digital 5.1 and ™ discrete four-channel gaming, giving you superior audio reproduction performance. DTT2200 is the ideal companion for the latest Sound Blaster Live! sound cards supporting 5.1-channel output. Enjoy Dolby Digital 5.1- channel surround sound using software DVD.
Page 5
Tripod stands for the rear satellites do not install or use the system. your DTT2200 system later. are available from www.creative.com Contact the retailer where the system was purchased.
Page 6
Note: The Subwoofer is not magnetically shielded, do not place it on your desktop or near the monitor. Place the front Satellites to the sides of Place the center Satellite as close to the center of your monitor as possible. The center For the strongest bass output, place the your monitor.
Page 7
Mount the rear Satellites only on walls that are structurally sound. Push back red tab on Satellite. Position the Satellites behind you and slightly above ear level. Insert bare end of red-banded cable into hole and release tab to lock. Repeat for unmarked cable; Apply rubber insert into black tab.
Page 8
The Front/Rear Balance Control need not be adjusted more than once during any single game. See “Controlling Noise and Distortion” on page 7 for related information. Peel off the protective strip from one side Remove the remaining mounting of the mounting tape . strip.
Page 9
To Sound Blaster Live! 5.1 series sound card Lime-green Lime-green(front), black(rear) and orange(center/sub) miniplugs. Black Orange Black 5.1-channel output is produced. Lime-green Orange Triple Stereo Line-in Audio Cable To 4-channel sound card Black Lime-green Lime-green Lime-green(front) and black(rear) miniplugs. Black 4.1-channel output is produced.
Page 10
Front Left Satellite Center Satellite Front Right Satellite To power source. To audio source. Note: Disconnect Subwoofer See “Audio Source from power source if Connection” on not in use for more page 5. than a few days. Power Supply Adapter Audio Connection Cable Rear Right Satellite Rear Left Satellite...
Page 11
Adjust the output control of your source’s volume control. audio card until the noise If you choose to use the DTT2200 disappears. This may require trial volume control, first set the and error. program source’s volume control high (at least 70% of the maximum level).
Page 12
Cambridge will warrant the speaker system other warranties, expressed or implied, audio scientists and built into Soundworks DTT2200 is an ideal 5.1 to be free of defects in material and of merchantability, fitness for purpose groundbreaking Personal Digital...
Need help?
Do you have a question about the DTT2200 and is the answer not in the manual?
Questions and answers