Aztec ULTRAGRIND Owner's Manual page 11

Propane concrete grinder and polisher
Table of Contents

Advertisement

• Coat a film of clean engine oil on seal of new
filter.
• Install new filter rotating it clockwise until
seal contacts mounting surface (B). Then
rotate filter 3/4 turn more by hand.
KAWASAKI ENGINE MAINTENANCE SCHEDULE
MAINTENANCE
Lubricate Pillow Block Bearings
Check and add engine oil
Check for loose or lost nuts and screws
Check for fuel and oil leakage
Check or clean air intake screen
Clean air cleaner foam element
Clean air cleaner paper element
Clean dust and dirt from cylinder and
cylinder head fins
Tighten nuts and screws
Change engine oil
Clean and gap spark plugs
Change oil filter
Replace air cleaner paper element
Clean combustion chambers
Clean and adjust valve clearance
Clean and lap valve seating surface
KAWASAKI ENGINE BATTERY START WIRING DIAGRAM
• Supply engine oil as specified.
• Run the engine for about 3 minutes, stop
Engine oil is a toxic substance. Dispose
of used oil properly. Contact you local
authorities for approved disposal
methods or possible recycling.
Daily
First 8 hr. Every 25 Hr. Every 50 hr. Every 100 hr. Every 200 hr. Every 300 hr.
engine, and check oil leakage around the
filter.
• Add oil to compensate for oil level drop due
to oil filter capacity (See "Preparation" for
oil level check on pg. 3).
WARNING!
INTERVAL
•*
ULTRAGRIND PG. 11
*After the 1st 50 hours

Advertisement

Table of Contents
loading

Table of Contents