Lan / Poe Connection; Reset Button; Power; Led Status Indicator - Elan EL-IO-200 Quick Install Manual

QUICK INSTALL GUIDE
For detailed wiring instructions, please refer to the Integration Note and documentation for
the connected device.

8. LAN / PoE Connection

The EL-IO-200 can be powered over Ethernet (PoE).The minimum PoE requirement is IEEE
802.3at. 42.5 - 57 VDC, 600 mA maximum.
Note: The EL-IO-200 can be connected via WiFi, however a wired connection is preferred.

9. Reset Button

Press and hold the reset button for 3 to 5 seconds to reset the network settings. The IP
address will be reset to DHCP if a static IP address has been assigned and if configured for
WiFi, will reset to an Ethernet connection.

10. Power

Once all other connections have been completed, connect an Ethernet cable connected to a
PoE switch or the 5 VDC, 2A power supply to the DC input.

11. LED Status Indicator

The LED communicates the status of the controller:
Blue
Power on / connected to network / connected to main controller
Flashing Blue
Power on / connected to network / NOT connected to main controller
12