Whirlpool Gladiator W10293036A Assembly Instructions Manual page 4

Install Shelves
F3b
F3b Phillips-head screw (8)
IMPORTANT: Install the shelf with magnetic closures (P6m) in the
upper position so the doors will close. The lower shelf may be
installed where desired.
1. Align the holes in the ends of shelf (P6m) with the set of holes in
the cabinet side (P1) that are second from the top.
NOTE: Make sure the long edge of the shelf with the closures is
facing out.
2. Using two Phillips-head screws (F3b) and two small flange
nuts (F4) per side, attach the shelf (P6) to the sides (P1).
3. Determine where you want to place the lower shelf (P6) and align
the holes in the ends of the shelf with the holes in the sides.
NOTE: Make sure the side with the two holes in the center is
facing out.
4. Using two Phillips-head screws (F3b) and two small flange
nuts (F4) per side, attach the shelf to the sides (P1).
P1
A
A
A. Phillips-head screws
B. Magnetic closures
5. Completely tighten the screws.
4
F4
F4 Small flange nut (8)
P2
P6m
B
P6
P1
P3
Install Doors
F3b Phillips-head screw (6)
The door hinges are designed with keyhole slots at the top and
bottom so the door will hang on the cabinet while you are fastening
the screws.
1. Start Phillips-head screws (F3b) in both the top and bottom holes
on each side of the cabinet.
2. Hang the right-hand side door (P7) from the top and bottom
screws, and hand tighten.
3. Insert the middle screw through the door hinge into the cabinet
and hand tighten.
P2
P6m
P6
P1
P3
4. Repeat steps 2 and 3 to attach the left-hand door (P8).
5. Align the doors and completely tighten the screws.
F3b
P7