Use Qhy168M In Ezcap_Qt - QHYCCD QHY600 User Manual

QHY600
08 Use QHY600 in EZCAP_QT
EZCAP_QT ( V0.1.51.18 ) is a software developed by QHYCCD. It has basic shooting functions for the
QHYCCD deep space camera. You can download and use it in the link below.
1. Install the EZCAP_QT software;
2. First connect the QHY600 to the 12V power supply, then connect the QHY600 camera to your computer
via the USB3.0 cable.
3. Start EZCAP_QT and click "Connect" in Menu->Camera. If the camera is successfully connected, the
title of EZCAP_QT software will display the firmware version of the camera and the ID of the camera, as
shown.
4. Click "Temperature Control" in "Camera Settings" to set the temperature of the CMOS sensor. You can
turn on "Auto" to set the target temperature. For example, here we set the target temperature to -10C. The
temperature of the CMOS sensor will drop quickly to this temperature (approximately 2-3 minutes). If you
want to turn off cooling, you can choose Stop. If you only want to set the cooling power without setting the
temperature, you can set the percentage of power.
5. You can use the preview tab to preview and use the focus tool to focus. Then use the Capture tab to
capture the image.
13