Use Qhy367C In Ezcap_Qt - QHYCCD QHY367C User Manual

05 Use QHY367C in EZCAP_QT

EZCAP_QT is the software developed by QHYCCD. This software has the basic capture function
for QHYCCD deep sky cameras.
1. Download and install
2. Connect your QHY367C to 12V power supply. Connect your QHY367C to your computer with
USB3.0 cable.
3. Run EZCAP_QT. Select "Connect" in Menu->Camera. If the camera is successfully connected.
The title of EZCAP_QT will display the camera firmware version and the camera ID as shown
below.
4. In Menu->Camera Setup, Click "Temp Control" and set the CMOS sensor temperature. You
can enable the "Auto Control" and set the target temperature. For example here we set the
temperature to -10C. The CMOS temperature will come to -10C very fast (in about 2-
3minute). If you want to close the TEC, you can select "TEC OFF". If you just want to set the
TEC power but not the temperature. You can select "Manual" and then set the percent of
the TEC power.
EZCAP_QT
10
QHY367C