Price Pfister Picardy T534 Series Manual page 3

7
7F
7E
7H
7G
7C
7D
7B
7 SECURING THREE HOLE FAUCET BODY
From underneath sink, place Washer (7A) and Locknut (7B) over Pull-Out Hose (7C)
and Supply Tubes (7D). Thread loosely onto faucet shank (7E). Make sure that Handle
(7F) is properly aligned to sink. Hand tighten Wing Nuts (7G) to Deckplate Shanks
(7H). Caution: do not over-tighten wing nuts. Remove any excess putty from around
the outside edge of Putty Plate (7J). Tighten faucet fi rmly to sink and use Flats (7K)
on Shank (7E) for leverage.
STOP
1 HOLE INSTALLATION
8
8D
8F
8H
8C
8A
8B
ENGLISH
7J
7K
7H
7G
7A
Go To Step 10 Go To Step 10
8E
8G
8J
8K
8C
8 ONE HOLE WITH SINGLE POST INSTALLATION
Place Metal Washer (8A) (make sure to use the thicker washer) and Rubber Washer
(8B) over center hole of sink and into the bottom of Mounting Ring (8C). Align Mounting
Ring (8C) to the center of sink hole. Remove Mounting Sleeve (8H) from Mounting Shank
(8F). Retract Pullout Hose (8D) up through Faucet Body (8E), until the pullout hose
fi tting is fl ush with the bottom of Mounting Shank (8F). Insert Faucet Supply Tubes (8G)
and Mounting Shank (8F) through the hole in Mounting Ring (8C).
Note: Tabs (8J) on Mounting Shank (8F) must be aligned with Grooves (8K) inside
Mounting Ring (8C).
Note: Do not feed the pullout Hose (8D) back down through the spout yet.
9
9F
9 SECURING SINGLE POST FAUCET BODY
From underneath sink, place Washer (9A) and Locknut (9B) over Pull-Out Hose (9C)
and Supply Tubes (9D). Thread loosely onto faucet shank (9E). Make sure that Handle
(9F) is properly aligned to sink. Tighten faucet fi rmly to sink and use Flats (9G) on
Shank (9E) for leverage..
10
10C
10B
10 QUICK CONNECT & WEIGHT ATTACHMENT
Insert the end of the Pull-Out Hose (10A) into the Weight (10B). Screw Quick Connector
(10C) to the free end of Pull-Out Hose (10A).
3
9E
9G
9C
9D
9A
9B
10A