Advertisement
3.1
Check the installation location
Before placing the appliance, please verify the overall measurements and the exact position of the
electrical connections looking at the pictures on the attached file "TECHNICAL DATA".
3.2
Feet assembly
CAPO 203 (XAV 203)- CAPO 303( XAV 303) –CAPO 403 (XAV 403)
You find the metal feet inside the appliance, in the carton box. They must absolutely be assembled in the
oven.
Do not ever use the appliance without its feet.
Screw the support feet with the relative washer in the bottom of the appliance
CAPO 603 (XAV 603)
The CAPO 603 must be installed with the rack provided. The plastic feet that you find inside the oven
must be installed . These feet are "insertion elements" for the racks.
3.3
Positioning
Make sure you have the correct power supply for the oven model you have purchased. Check the
technical data sheets attached if you are in doubt.
Do not install any Cadco Combination Oven directly on the floor.
If the oven must be placed near walls, dividers, or moldings Cadco recommends they be made of non-
combustible materials. Be sure to observe all safety and fire codes when positioning your Combi Steam
Convection oven.
All of our Combi Steam Convection ovens have a vapor vent in the back of the unit. When installing your
convection oven, leave a space of 4" [minimum] between the back of the oven and the wall, and 2"
minimum on the top and sides.
Where applicable, ventilation hood requirements vary according to local codes.
We do not suggest using the Cadco-Unox Combi Steam Convection Ovens for built in applications.
Measure to make sure that your new oven will fit in your available space.
3.4
Remove the protective film
Carefully remove all the protective film from the external walls of the appliance. Pay attention not to
leave any residue of glue on the sides.
If there should be any residue, remove it with an appropriate solvent.
4.
INSTALLATION
4.1 – ELECTRICAL CONNECTION
4.2 – WATER CONNECTION
4.1
Electrical connection
a-The connection to the electrical power supply system must be done according to all governing codes.
Before connecting the appliance, make sure that the voltage and the frequency correspond to those stated
on the data plate of the appliance. The appliance must be placed so that the connection plug to the
network can be easily reached.
3
Advertisement
