At+Enq; At+Reset; At+Baud - LM Technologies LM048 At Command Manual

2.8.2.1 Syntax
AT+VER<cr>
2.8.2.2 Response
<cr,lf>FW VERSION: vX.YZ<command_response>
Where X: Major release of device firmware
YZ: Minor release/updates of device firmware
e.g. FW VERSION: v4.50

2.8.3 AT+ENQ

List all the device information and all the settings along with their brief description. The settings
include serial port, Bluetooth related and other misc settings.
2.8.3.1 Syntax
AT+ENQ<cr>
2.8.3.2 Response
<command_response>
<cr,lf><Parameter Setting, Brief Description><cr,lf> for each parameter.
e.g. device role setting will be listed as "<cr,lf>ROLEM, MASTER ROLE <cr,lf>". All other
settings and other device information is listed in similar manner.

2.8.4 AT+RESET

This command is used to restore the default factory settings and perform device reboot. The default
factory settings are listed in table [reference]
2.8.4.1 Syntax
AT+RESET<cr>
2.8.4.2 Response
<command_response>

2.8.5 AT+BAUD

The command allows setting the baud rate for the serial UART port. The current baud rate setting
can also be retrieved by using the sending this command in query format.
2.8.5.1 AT+BAUDb<cr>
where b – varies from 10 to 19 for different baud rates. The baud rate varies from 1200bps
to 921 Kbps. e.g. To set 19200 as UART baud rate, the command is AT+BAUD14<cr>
b
10
11
12
13
14
15
16
@2010 LM- Technologies Ltd
AT Command Manual
Baud rate (bps)
1200
2400
4800
9600
19200
38400
57600
www.lm-technologies.com
v1.2
Page 7 of 16