Advertisement
Assembly instructions: to assemble the cabinet, perform the following steps.
[NOTE: Numbers in parentheses correspond to item numbers in the exploded parts diagram on p. 3.]
Step 1 – Fasten the back plate (6) to the side panels
5
(5) with
/
in. hardware (9, 10 and 11). The
16
back plate attaches to the outside of the side
panels.
a. Notice that one side of the back plate has only
2 bolt holes (there are three in each of the
other sides). This is the bottom side of the
back plate.
b. Also notice that each side panel has an edge
with 2 "hinge slots" cut out of it. This is the
front edge of a side panel.
5
c. Insert a
/
in. – 18 x
16
middle and bottom holes in the back plate and
the side panel as shown in the diagram to the
right.
d. Fasten the back plate to the other side panel
in the same manner. Do not tighten the bolts
and nuts at this time.
Step 2 – Attach the base plate (2) to the side panels
a. Look at the base plate and notice that on two edges notches are cut out of the corners. These are the front
and rear edges of the base plate. The front and rear edges are identical.
b. Set the base plate inside the assembly and align the large bolt holes in the plate with the bolt holes in the
flange of the side panels.
c. Place the cabinet in the location where it will be used. If you will anchor the cabinet to the ground, mark the
ground/surface with the locations of all 4 bolt holes. The bolt holes will accept
bolts. Your building engineer should select anchor bolts of appropriate length.
Top side of base plate
Bottom side of base plate
Rev. 5/16/2014
3
/
in. bolt (9) through the
4
Anchor bolt hole
Front / Back
edge
Copyright 2014 Vestil Manufacturing Co.
Page 4 of 8
Side
panel (5)
Back
RS
plate (6)
Bottom side
of back plate
RB
CYL-H-4-KD, manual.doc
Hinge slots in front
edges of side panels
LS
RB
Side
panel (5)
1
/
in. (diameter) anchor
4
RS
Anchor
bolt hole
Front edge of
base plate
Advertisement
