Whirlpool 7MWFC9822HC Use And Care Manual page 19

NON-USE AND VACATION CARE
If moving, or not using your washer/dryer for a period
of time, follow these steps:
1. Unplug or disconnect power to washer/dryer.
2. Turn off water supply to washer/dryer to avoid flooding
due to water pressure surges.
HELPFUL TIP: Attach a reminder note to the washer/
dryer to turn the water back on before washer's next use.
3. Clean the dispensers. See "Cleaning the Dispensers."
WINTER STORAGE CARE
IMPORTANT: To avoid damage, install and store washer/
dryer where it will not freeze. Because some water may stay
in hoses, freezing can damage washer/dryer. If storing or
moving during freezing weather, winterize your washer/dryer.
To winterize washer/dryer:
1. Shut off water faucet, disconnect and drain water
inlet hose.
HELPFUL TIP: Attach a reminder note to the washer/
dryer to turn the water back on before washer's next use.
2. Remove drain pump filter.
3. Put 1 qt. (1 L) of R.V.-type antifreeze in drum and run
washer/dryer on Normal cycle for about 2 minutes to
mix antifreeze and remaining water.
4. Unplug washer/dryer or disconnect power.
TRANSPORTING YOUR WASHER/DRYER
1. Shut off water faucet. Disconnect and drain water inlet
hose.
2. If washer/dryer will be moved during freezing weather,
follow "Winter Storage Care" directions before moving.
3. Disconnect drain hose from drain system and from back
of washer/dryer.
4. Unplug power cord.
5. Place inlet hoses and drain hose inside drum.
6. Bundle power cord with a rubber band or cable tie
to keep it from hanging to the ground.
IMPORTANT: Call for service to install new transport
bolts. Do not reuse transport bolts. Washer/dryer must
be transported in the upright position. To avoid structural
damage to your washer/dryer, it must be properly set up
for relocation by a certified technician.
REINSTALLING/USING
WASHER/DRYER AGAIN
To reinstall washer/dryer after non-use, vacation, winter
storage, or moving:
1. Refer to the Installation Instructions to locate, level,
and connect washer/dryer.
2. Before using again, run washer/dryer through the
following recommended procedure:
To use washer/dryer again:
1. Flush water pipes and hoses. Reconnect water inlet
hoses. Turn on water faucets.
2. Plug in washer/dryer or reconnect power.
3. Run washer/dryer through Heavy Duty cycle to
clean washer/dryer and remove antifreeze, if used.
Use only HE detergent. Use half the manufacturer's
recommended amount for a medium-size load.
19