Bison HHBD01SK-01 Operating And Maintenance Manual page 10

Power Supply Connection
The power supply cable connects directly to the trolley's switch box. [WARNING: It is advised to use a
certified electrician when connecting the unit to the mains power supply]
1. After removing the switch box cover insert the cable into the switch box.
2. Allow enough cable length in the switch box for a comfortable connection. (the wires should never be
tightly drawn from their terminals point)
3. Fasten together cable holder A and B.
4. Connect the black, red and white wires to the terminals 1, 2 and 3 as shown above. Connect the green
and yellow (ground) wire to the ground terminal on the side of the terminal strip.
5. After all wires are tightly fastened in their terminals, seal the box with the cover.
(make sure no cables were twisted during these steps)
10