"Overheating Protection" Function; Switching Off The Appliance; Device Control - Electrolux ECH/AG2-1000 3BI-W EEC User Manual

8
www.home-comfort.com
Setting up the Program
Select the day of
the week for
settings
Setting up the Custom
Choice of hours for
settings (allocated
7 hours)
"Open window" function
When this function is active, when the
temperature drops within 10 minutes (and then
up to 30 minutes) by 5 or more degrees -
the Anti-Frost mode is switched on the heater.
If in the time interval 10 - 30 minutes the
temperature continues to drop, the device
turns off. Further, the heater waits for the
stabilization of the decrease in the room
temperature, if it rises by 2 degrees, then
the last set mode is turned on.
"Parental control" function
Locks all buttons on the control panel. While
the instrument is operating, press and hold the
left and right arrow buttons simultaneously for
a few seconds. The lock indicator lights up on
the display. The Parental Control function
is activated. To disable the function, repeat
the same operation as to enable.
"Auto Restart Resume" function
In the event of a short-term power outage,
and its further inclusion, the convector
automatically switches to the operating mode,
Schedule type
selection for
monday
Work mode
selection for a
specific hour
Schedule
example P1
Command
confirmation
while maintaining the last operating mode of
the device and the set temperature (if a timer
was set, the set shutdown time is saved). If the
device was in standby mode when the power
was turned off, it will remain in the same mode
when the power supply is restored.

"Overheating protection" function

The device is equipped with an automatic
switch that is activated when the upper
temperature limit is reached. The heater
switches off automatically in case of
overheating. After eliminating the source
of overheating, the heater will turn on
automatically.

Switching off the appliance

To turn off the device, press the button
in any operating mode.

Device control

Preparation for work
1. Carefully remove the heater from the
cardboard box.
2. Remove the colored stickers from the front
panel before use.
Command
confirmation
Set next hour for
settings