Specifications - Electrolux ECH/AG2-1000 3BI-W EEC User Manual

10 www.home-comfort.com
Troubleshooting
Malfunction
symptom
No heating
Smell of burnt dust
when first turned on
If after trying all the troubleshooting steps, the problem is not resolved, contact an authorized service cen-
ter in your area or your sales representative.

Specifications

Model
Power, W
Rated power consumption, W
Rated current, A
Rated voltage, V~Hz
Ingress protection class
Electrical protection class
Heating area, m
2
Appliance size (W×H×D), mm
Packing size (W×H×D), mm
Net weight, kg
Gross weight, kg
* Indicated is a guideline value and may differ depending on actual conditions of use
The convector is supplied with a sticker on
the front panel. Remove it before using the
device.
Troubleshooting
E1 - temperature sensor malfunction
E2 - overheating in the room is more than
50 ºC If these errors occur, contact your
dealer.
Cause of malfunction
1) There is no power supply.
2) The convector is in standby mode.
3) The actual room temperature is higher
than the thermostat setting.
Not a malfunction
ECH/AG2-1000
3BI-W EEC
900-1000
900-1000
4.1-4.17
220/240~50/60
IP24
10-12
480×413×129
575×445×157
3.61
4.47
1) Establish a reliable connection.
2) Set the convector to operating
mode.
3) Adjust the temperature mode of the
convector.
The smell disappears after a few
minutes of convector operation
ECH/AG2-1500
3BI-W EEC
1350-1500
1350-1500
6.14-6.25
220/240~50/60
IP24
I I
13-15
560×413×129
655×445×157
4.27
5.3
Troubleshooting steps
ECH/AG2-1800 ECH/AG2-2200
3BI-W EEC 3BI-W EEC
1600-1800 2000-2200
1600-1800 2000-2200
7.27-7.50 9.1-9.17
220/240~50/60 220/240~50/60
IP24 IP24
I
18-20 22-25
640×413×129 800×413×129
735×445×157 895×445×157
4.5
5.6
I
5.3
6.8