General Safety Notes - Promac 322BE1-BP Manual

3.2 General safety notes

Metalworking machines can be dangerous if
not used properly. Therefore, the appropriate
general technical rules as well as the following
notes must be observed.
Read and understand the entire instruction
manual before attempting
operation.
Keep this operating instruction close by the
machine, protected from dirt and humidity, and
pass it over to the new owner if you part with
the tool.
No changes to the machine may be made.
Daily inspect the function and existence of the
safety appliances before you start the machine.
Do not attempt operation in this case, protect
the machine by unplugging the power cord.
Before operating the machine, remove tie, rings,
watches, other jewelry, and roll up sleeves
above the elbows.
Remove all loose clothing and confine long hair.
Wear safety shoes; never wear leisure shoes
or sandals.
Always wear the approved working outfit:
- safety goggles
- ear protection
- dust protection
Do not wear gloves while operating this
machine.
Install the machine so that there is sufficient
space for safe operation and workpiece
handling.
Keep work area well lighted.
The machine is designed to operate in closed
rooms and must be bolted stable on firm and
assembly or
levelled table surface
Make sure that the power cord does not
impede work and cause people to trip.
Keep the floor around the machine clean and
free of scrap material, oil and grease.
Stay alert!
Give your work undivided attention.
Use common sense. Do not operate the
machine when you are tired.
Keep an ergonomic body position. Maintain a
balanced stance at all times.
Do not operate the machine under the influence
of drugs, alcohol or any medication. Be aware
that medication can change your behavior.
Never reach into the machine while it is
operating or running down.
Keep children and visitors a safe distance from
the work area.
Never leave a running machine unattended.
Before you leave the workplace switch off the
machine.
Do
inflammable liquids or gases.
Observe the fire fighting and fire alert options,
for example the fire extinguisher operation and
place.
6
not operate the electric tool near