Table of Contents
Advertisement
Loose Parts in Rectangle Box
Figure
Title
Q'ty
ASSEMBLY CHART-SANDING DEVICE
1
1. Remove the left side hex. Nut from shaft
2. Place frame assembly in. tighten cap screw by
6mm hex. Wrench (Supplied)
3. Mount the rubber into frame assembly tighten
hex. Nut firmly by socket wrench (supplied)
Sanding Frame
Assembly
1
Sanding Belt
Protection Cover
1
2
1. Observe aluminum roller whether it's tail end is
at the right angle (90∘) to the frame. (Turn
tracking knob clockwise may make the tail end
of roller upward)
2. Turn belt tension knob clockwise about 120∘to
make aluminum roller downward and locate
sanding belt on the center of rollers.
3. Turn belt tension knob counter-clockwise 120∘
back to tie belt up.
11
Rubber Roller
1
1
Advertisement
Table of Contents
