Sony HXR-NX5C Service Manual page 39

3-1. ASSEMBLY
Assembly-1: Confirm the Diopter Adjustment Lever
is on the left side when installing the VF
Lens Assy.
VF Lens Assy
Diopter
Adjustment
Lever
Eye Cup (93000) Assy
Assembly-2: How to arrange Harnesses (SW-116).
Panel Hinge
Claws Harness (SW-116)
Cabinet (B)
Assembly-3: How to bent the Speaker Grille.
Bend the hole of
Speaker Grille.
Speaker Grille
Bent the Speaker Grille.
HXR-NX5C/NX5E/NX5J/NX5M/NX5N/NX5P/NX5U
Assembly-4: How to arrange Harnesses and Flexible
Board.
The Harness (SW-116) wrap around
the Harness (Coaxial cable).
Harness
(SW-116)
Harness
(Coaxial cable)
Arrange the harness Coaxial Cable and
SW-116 under the flexible holder.
Arrange FP-1150 flexible
board inside the pin.
Harness (Coaxial cable),
Harness (SW-116) Claw
Pin
FP-1150
Flexible
Board
PI-029 PI-029 PI-030
Flexible
Holder
Harness
(Loudspeaker (1.8cm))
Roll up the harness (Loudspeaker
(1.8cm)) to the claw.
3. ASSEMBLY
Assembly-5: On installation of the GS-010 Board,
adjust the position of the switch.
(EXCEPT NX5C/NX5M)
GS-010 Board
Switch
Assembly-6: On installation of the TS-157 Board,
adjust the position of the switch.
Switch
3-1E
Assembly-7: On installation of the Cabinet (R)
section, adjust the position of the ND
filter switch.
ND Filter Lever
Assembly-8: How to arrange Harness
TS-157 Board
(Coaxial Cable).
VC-582
Harness Harness
(Coaxial Cable) (Coaxial Cable)
(R) (G)
Cabinet (R) Section
ND Filter Switch
Harness
(Coaxial Cable)
(B)