Delta 538T-DST Series Quick Start Manual page 20

Check for leaks at arrows. Refer back to
the appropriate installation instructions
and retighten if necessary, but do not
Examine si hay fugas en los lugares
indicados con las flechas. Refiérase a las
instrucciones de instalación adecuadas
y vuelva a apretar si es necesario, pero
Vérifiez l'étanchéité aux endroits
indiqués par les flèches. Au besoin,
consultez les instructions d'installation
et resserrez les raccords. Si les rac-
overtighten. If assembled correctly and
still leaking, check for damage to seals
and order appropriate replacements.
no apriete demasiado. Si se ensambla
correctamente y continúan las fugas,
examine si hay daños en los sellos y
ordene repuestos adecuados.
cords sont bien serrés, vérifiez les garni-
tures d'étanchéité pour voir si elles sont
abîmées et commandez les pièces de
rechange nécessaires.
37
538T-DST, 15938T-DST 551T-DST & 751T-DST
& 15960T-DST
5
5
4
4
3
3
1
1
6
6
2
2
Maintenance
If faucet exhibits very low flow:
A. Remove aerator (1) with supplied
wrench (2) and clean, or
B. SHUT OFF WATER SUPPLIES. Replace valve
cartridge (3). When reinstalling parts, make sure
bonnet nut (4) is tightened securely with
a wrench.*
If faucet leaks from under handle:
Remove handle and remove trim cap (5). Using
a wrench, ensure bonnet nut (4) is tight.
If leak persists–SHUT OFF WATER SUPPLIES.
Replace valve cartridge (3). When reinstalling parts,
make sure bonnet nut (4) is tightened securely with
a wrench.*
If faucet leaks from spout outlet–SHUT OFF
WATER SUPPLIES. Replace valve cartridge (3).
When reinstalling parts, make sure bonnet nut (4) is
tightened securely with a wrench.*
* WARNING: Failure to securely tighten bonnet
nut with a wrench could result in water damage.
Note: Do not attempt to disassemble cartridge (3).
There are no repairable parts inside.
592T-DST 561T-DST & 761T-DST
5
5
4
4
3
3
1
2
1
6
2 6
Flow Restrictor Inside
Restrictor de flujo interior
Limiteur de débit à l'intérieur
LED Guide
If LED (6) is:
Solid Blue - Solenoid valve is open, water
° ° ).
temperature is less than 80
F (27 C
Solid Magenta - Solenoid valve is open, water
° °
temperature is between 80 C) and 110
F (27
°
(43 C).
Solid Red - Solenoid valve is open, water
° °
temperature is greater than 110
F (43
3 red flashes before solenoid opens or closes -
replace batteries.
Note: If low battery indication is on after
installing fresh batteries, please check that
batteries are loaded in the proper direction in
the battery box.
Solenoid Troubleshooting
Note: Normal operation of the faucet will turn
off water flow if faucet is not touched for 4
minutes.
1. If your spout flashes a red light on then off
and then keeps repeating this,
replace the batteries.
38
°
F
C).