Bushnell Videoscope 73-7000V Instruction Manual page 7

Charging the VideosCope
The Videoscope is powered by an internal, rechargeable lithium-ion battery. Before using
the Videoscope for the first time, it needs to be charged for approximately 10 hours (future
charge times should be shorter)..
1. Plug the supplied USB cable into the AC Adapter (using the large, standard rectangular USB
plug), then insert the other end of the cable into the UsB port.on.the.side.of.the.Videoscope..
2. Plug the AC Adapter into a wall outlet. The status Led on top of the Videoscope will glow
red, turning green when the battery is fully charged (the light on the AC adapter is just a power
indicator and will remain red). You may want to simply let the battery charge overnight-it will
not overcharge if left plugged in for longer than 10 hours. Note: A 12v DC car lighter plug is
also supplied for convenient recharging in the field; however the initial full charge should be
done using an AC outlet. The car lighter plug is best used for restoring the battery to full charge
when it is becoming low, or only partly discharged.
3. The AC adapter can then be unplugged, and the USB cord removed from the Videoscope.
.
AC Adapter+USB Cable
Videoscope 6LIM draft rev1.indd 7
AC Adapter Connected to Videoscope
.
Car Lighter Plug
10/29/07 12:51:07 PM