Cdm Block - Sony MHC-V6D Service Manual

MHC-V6D
2-6.

CDM BLOCK

Wire
CDM block
ARAGON board
Note 1: Connect the wire from the CDM
block to the ARAGON board and
place it neatly inside the CDM
block.
1 screw
(BVTP3
Note 2: When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
OK
Insert straight into the interior.
flexible flat
cable
colored line
connector
12
6 flexible flat cable
(24P) (CN302)
5 flexible flat cable
(5P) (CN303)
4 connector
(CN401)
10)
–
NG
Insert at a slant.
flexible flat
cable
colored line
connector
7 CDM block
1 screw
(BVTP3 10)
2 two hooks
–
Note 3: Insert the connector straight into the interior.
There is a possibility that using this device without
the connector correctly installed will damage it.
OK NG
Insert straight into
Insert only part way.
the interior.
connector
connector
connector connector
3 Remove the CDM block
in the direction of the arrow.
1 two screws
(BVTP3 10)
NG
Insert at a slant.
connector
connector