Honeywell NEXH Series Installation&Operation Manual Book page 20

Camera Function
② White Balance Mode Control
: It displays and changes White Balance Mode Control
status of Camera. ( According to Mode, it just display the state
and not to adjust.)
ATW AUTO
INDOOR 3200°K
OUTDOOR 5400°K
MANUAL R/B CTRL
LOCK →PUSH
AWC
AWC AUTO
(LOCK means Manual white balance status. Press
NEAR(+) / FAR(-) key continuously, LOCK mode becomes
PUSH mode and white balance acts automatically, and then
white balance mode is locked as manual.)
<< WB MODE >>
MODE
CONTROL
RED
BLUE
RETURN
< WB MODE >
③ RED GAIN (Range is different on each Mode.)
: Adjust RED Gain, and tune the sensitivity of white point.
-20 → -19 → .... → 19 → 20
ATW
0 → 1 → .... → 254 → 255
MANUAL
AWC 30 (Current RED gain display)
④ BLUE GAIN (Range is different on each Mode.)
: Adjust BLUE Gain, and tune the sensitivity of white point.
-20 → -19 → .... → 19 → 20
ATW
0 → 1 → .... → 254 → 255
MANUAL
AWC 30 (Current BLUE gain display)
AWC
AUTO
0
0
7-4. BLC/BMB Mode
① Backlight Compensation Mode
: It is for preventing the center object getting too dark when
the excessive light is behind the central object.
Set BACKLIGHT ON, then the center object gets brighten
in the contrast to the background light.
MODE
(WDR [Wide Dynamic Range] function combines dark
area's image and bright area's image inside memory, and
makes a subject shown more clearly.)
( BMB [Black Mask BLC] is different backlight
compensation, mask the excessive light and make objects
look clearly.)
② Backlight Compensation Level (BLC, ABLC, WDR, BMB
Level)
LEVEL
<< BLC MODE >>
MODE
LEVEL
AREA SEL
BMB COLOR
RETURN
< BLC MODE >
③ BMB Color selection: User can select masking color of
BMB
BMB MASKING
AREA SEL : User can select area for BMB.
If you press MENU at AREA SEL, you can configure the area
of BMB.
< BMB MODE areas setting >
- 20 -
OFF → BLC → ABLC → WDR → BMB
5 ( 0 ~ 20 )
BMB
5
BLACK
BLACK →D.GRAY → ... → WHITE