When installing the Power Distribution Center cover, it is important to ensure the cover is properly positioned and fully latched. Failure to do so may
allow water to get into the power distribution center and possibly result in an electrical system failure.
When replacing a blown fuse, it is important to use only a fuse having the correct amperage rating. The use of a fuse with a rating other than indi-
cated may result in a dangerous electrical system overload. If a properly rated fuse continues to blow, it indicates a problem in the circuit that must
be corrected.
* If Equipped
Micro Fuse
10 Amp Red
Rear Console Lamp / Rear Power Outlet
20 Amp Yellow
Cigar Lighter
10 Amp Red
Shifter/Transfer Case Module
10 Amp Red
Rear Camera / Blind Spot Sensor*
10 Amp Red
Run Relay Coil feed
10 Amp Red
Climate Control/Driver Assistance Systems Module/HALF/Park Assist*
15 Amp Blue
In Car Temp Sensor / Humidity Sensor
15 Amp Blue
Spare
10 Amp Red
Rear HVAC
20 Amp Yellow
Power Outlets (Instrument Panel/Center Console/Rear Cargo*)