Set New Recipe (No Smart Funnel Nor G9-2T Dbc Or Mhg Grinder) - Bunn Dual SH BrewWISE DBC Installation And Operating Manual

PROGRAMMING THE BREWER (cont.)
SET NEW RECIPES (cont.)
SET NEW RECIPE:
If not using a Smart Funnel (with a computer chip)
and/or a G9-2T DBC or MHG Grinder, the brewer will
function as a standard Bunn Dual Brewer:
It is possible to operate the brewer without using
a Smart Funnel and/or a G9-2T DBC or MHG Grinder.
If a standard funnel, or if a non-DBC grinder is used
the brewer will automatically select a NO NAME coffee
when the BREW switch is pressed. This means that
no name was read from the funnel's handle.
There are two NO NAME coffee programs that
can be set in the brewer. They are referred to as NO
NAME LEFT and NO NAME RIGHT. The left and right
sides of the brewer can be set up independently of
each other. This includes BREW VOLUMES, BYPASS
PERCENTAGES, PULSE BREW TIMES, and DRIP-OUT
TIMES. The brewer will perform in the same capacity
as a standard Bunn Dual Brewer.
The instructions for programming the NO NAME
settings are on the following pages. The same steps
are followed for setting the recipe as those that are
used to MODIFY A RECIPE, beginning on page 21.
Note that when the display reads NO NAME LEFT,
that is when MODIFY should be pressed in order to
set the parameters for the NO NAME LEFT coffee.
Otherwise, press NEXT to display NO NAME
RIGHT.
At this point, MODIFY should be pressed in order to
set the parameters for the NO NAME RIGHT coffee.
NOTE: Before beginning setup, insert a funnel into the
left and right side funnel rails, and place a Soft Heat
Server beneath each brew funnel.
REVIEW RECIPES?
NO
EXIT TO
NEXT FUNCTION
SCREEN
NO-NAME LEFT
MODIFYSHOWNEXT
BREW OZ. XX.X
(-) DONE
Page 20
YES
NO-NAME RIGHT
MODIFYSHOWNEXT
(+)
BREW OZ. XX.X
(-) DONE (+)
P2419
29877-3 062005