Advertisement
4. INSTALLATION INSTRUCTION
This section explains how to install your appliance for the most energy-efficient, safe and quiet operation.
If possible avoid placing the appliance near cookers,
radiators or in direct sunlight as this will cause the
compressor to run for long periods. If installed next to a
source of heat or refrigerator, maintain the following
minimum side clearances:
From Cookers
From Radiators
From Fridges
•Make sure that sufficient room is
provided around the appliance to ensure
free air circulation. Ideally, A space of no
less than
100mm
freezer, and ensure you allow gaps as
shown in the below diagram.
The appliance should be located on a smooth surface.
It is forbidden to use the refrigerator outdoors.
Protection from moisture. Do not locate the freezer in moist space to avoid the metal parts rusty. And
do not spray water to the freezer, otherwise it will weaken the insulation and causes current leakage.
Refer to "Cleaning and Care" section to prepare your appliance for use.
If the freezer is installed in unheated areas, garages etc. condensation may form on the outer
surfaces in cold weather. This is quite normal and is not a fault. Remove the condensation by wiping
with a dry cloth.
must be left around the
4
4"
(100 mm)
12" (300 mm)
4"
(100 mm)
Advertisement
