Table of Contents
Advertisement
2. Select Start / Run.
3. Input "Telnet <WLM-L11G's IP address>"
in the file name and press "Enter". The IP
address can be identified through the
Client Manager or Terminal Software setup
screen.
4. When login prompt appears, enter "root"
as a default login name.
5. Input "?"/press "Enter" to view list of
commands.
PART III
8.0 Detailed Configurations
8.1 Introduction III
Although your AirStation will work fine in
most network environments, you may wish to
explore the advanced options. This chapter
explains each parameter in the setup screen.
8.2 Basic Settings
Basic Settings includes the following param-
eters:
AirStation Name
Connection type
IP address
Default Gateway
DNS Server
8.2.1 AirStation Name
A unique name can be set for your AirStation
in order for clients to recognize it. It identifies
each access point when multiple access
points are present. Although it is not
necessary to set this parameter, it can be
useful. Once it is set, the name will be shown
at the top of the initial setup screen.
8.2.2 Connection type
The following options are possible for the
wired LAN port setting:
10 Mbps Half Duplex
100 Mbps Half Duplex
Auto
If the port on the LAN hub is set to Full
Duplex, set the WLM-L11G to Auto.
8.2.3 IP Address
If you do not use a DHCP server on your
network, you have to assign an IP address
manually. A specific IP address should be
obtained for this. You can use DHCP by
selecting "auto IP assignment from DHCP
Server."
8.2.4 Default Gateway
A default gateway IP should be assigned to
the AirStation. If the gateway IP is unknown,
leave the box blank. If "Auto IP assignment
from DHCP Server" is selected, the gateway
IP will be assigned automatically.
8.2.5 DNS Server
Input the IP address of the server to be used
by the WLM-L11G for DNS resolution. If
DNS is not used, leave blank.
8.3 Time Settings
Input the correct time manually or input the
NTP server on your network. Using NTP
Server: Check the "Use" box. Specify the
NTP server name, check interval, and time
zone.
Figure 8.3
Time settings
9
Advertisement
Table of Contents
