Network Administration Features - Buffalo WLM-L11G User Manual

Figure 5.2.2
Link
integrity
Figure 5.3.1
Load
Balancing
4
Spanning Tree in a network loop disconnects
one of the links, rerouting the traffic in the
event of failure, avoiding packet sending
repetition and increasing network stability.
5.3 Network Load Distribution
Features
5.3.1 Load Balancing
This feature enables automatic selection of
an available access point with the least load
among multiple APs. It allows easy roaming,
and the network stability can be increased
significantly through even distribution of the
traffic load.
5.3.2 Repeater
The WLM-L11G AP can act as a repeater to
other APs. This feature provides a solution
for clients operating in the "dead zone,"
where signal does not reach. Combination of
this function and add-on antennas can offer
extended range.
5.3.3 WDS – Wireless Distribution System
WDS is used to create access-point to
access-point communications when a CAT5
cable cannot be used or is unavailable. Similar
to repeating, it is primarily used to extend the
reach of the WLAN. Displaying the name of
the available AirStation while roaming is also
possible.

5.4 Network Administration Features

5.4.1 SNMP – Simple Network Management
Protocol
The WLM-L11G AP supports SNMP. Each
unit acts as an SNMP agent so that the
network connection status and configuration
information may be accessed remotely
through the SNMP manager, which enables
centralized traffic and fault monitoring.
5.4.2 Syslog
This feature allows sending a copy of the
system log to the Syslog server automatically.
The log contains information on the operating
status of each device, which enables real-time
monitoring of operational data, fault data, user
login data and other such information.
Although the WLM-L11G model supports
the Syslog server as a part of its administra-
tive utilities, it is possible to use additional off-
the-shelf Syslog server software.
5.5 Easy Support Features
Buffalo periodically releases new firmware
updates for AirStation products. The firmware
is easily uploaded to the AirStation from a PC.
Look for new firmware releases on the
www.buffalotech.com website.