Advertisement
REPLACING SLATS ON PLASMA
CUTTING TOP WITH #21275 SLAT KIT
• Remove Plasma Cutting Top from work stand.
• Place top upside down on a flat surface.
• Remove 3 bolts from one frame cross member assembly with a 17mm wrench
and withdraw the slotted cross member beam (FIG 5).
• Loosen (do not remove) the 3 bolts on the opposite cross member.
• Remove all or some of the slats as required.
• Replace Slats.
• Line up slots and replace beam and Retaining Bolts.
• Tighten remaining bolts.
ADDITIONAL ITEMS
#13689
Plasma Cutting Guide
#20188
Magnetic Plasma Cutting Guide
#30722
Corner Vise
#20162
6pc Clamp Kit
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: techelp@eastwood.com
© Copyright 2017 Easthill Group, Inc.
If you have any questions about the use of this product, please contact
PDF version of this manual is available online >> eastwood.com/21273manual
The Eastwood Company
263 Shoemaker Road, Pottstown, PA 19464, USA
US and Canada: 800.343.9353
Fax: 610.323.6268
FIG. 5
Outside US: 610.718.8335
eastwood.com
1/17
Instruction Item #21273Q
Rev. 3
Advertisement
