Advertisement
ASSEMBLY
• Remove Foam Padding from existing work stand.
• The center-to-center dimension between the tops of the work stand tubes
must be set at 23" [584mm] (FIG 1).
• Most stands rely on chains, "Eye" hooks and "J" hooks to support the
spread of the tubular members.
- First, place the chain links into the "J" hooks that most closely provide
the 23" [584mm] top-tube CL to CL dimension (FIG 1).
- Some fine tuning, in-and-out adjustment of the mounting of the
"J" and "Eye" hooks may be required (FIG 1).
• Carefully set the #21273 Welding Top or the #21274 Plasma Cutting Top
with the open end of the brackets over the tops of the work stand tubes
(FIG 2). IMPORTANT NOTE: If using both tops, carefully swing the
previously mounted one up, over and allow it to hang (FIG 3).
• Note that the Spacers are threaded. Place one of the Spacers under the
tube and between the tabs of the bracket.
• Insert an M6 x 12mm tapered screw through the countersunk hole and
thread into the Spacer (FIG 4).
• Insert an M6 x 12mm pan head screw into the backside hole of the
bracket and thread into the Spacer.
• Once both screws have started threading, they should then be tightened.
• Repeat for remaining screw and spacer.
• The Eastwood Welding Top and/or Plasma Cutting Top is now ready
for use.
TECH TIP: Mark the appropriate chain link before folding the
stand for storage so that the 23" [584mm] top
tube spacing dimension can be quickly returned
to the next time the stand is needed.
INJURY HAZARD!
• Exercise caution when using Plasma Cutting Table Top
to keep the cutting area centered over the Cutting Slats.
Failure to do so could result in damage to the Table Top
or Folding Stand structure causing an unsafe condition
due to reduced load capacity.
• Inspect Table Tops and Stand before each use for loose,
broken, or damaged components. Do not use tables if
any components are damaged or not properly adjusted.
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 1
Adjust to: 23" [584mm]
Center to Center
" " " "
In
Out
FIG. 2
FIG. 3
FIG. 4
Screw
In
Out
Spacer
3
Advertisement
