Advertisement
4. OPERATION
4.1
Insert the end of the hose into a suitable container. start operating the pump handle, the initial strokes should be rapid to help prime the
pump, the pump should start to dispense the fluid within seven strokes of the pump handle.
NOTE: DO NOT use undue pressure on the pump handle as this may cause the pump neck to fracture.
4.2
When pumping is completed, insert the nozzle into the nozzle holder. the handle may be locked into position using the latch on the
pump body and a padlock.
5. TROUBLESHOOTING
Problem
Pump does not dispense or flow is restricted
Leakage of fluid from pump handle piston
Parts support is available for this product. To obtain a parts list and diagram please log on to:
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Pump outlet
Locking Latch
Pump Body
Pump Inlet
Bung nut
telescopic
suction tube
Cause
Pump not able to create adequate suction
Pump is drawing in air instead of fluid
Pump inlet is blocked
Damaged seal due to incompatible fluids
www.sealey.co.uk, email sales@sealey.co.uk or phone 01284 757500
Sole U.K. Distributor
Sealey Group
Bury st. Edmunds
suffolk.
Pump Handle
nozzle
Holder
01284 757500
01284 703534
Dispensing
nozzle
Remedy
Prime pump, see section 4.1
tighten suction tube to pump inlet
connection
Extension seal failure between
suction tube sections
remove suction tube and clean
wire mesh screen at pump inlet
return to your sealey dealer
www.sealey.co.uk
Web
sales@sealey.co.uk
e-mail
tP6918
Issue no: 1 - 19/08/08
Advertisement
