Sealey TP67 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
WARNING! Ensure all health and safety, local authority, and general workshop practice regulations are strictly adhered to when
‰
using this equipment.
Familiarise yourself with the application and limitations of this product, as well as the specific potential hazards peculiar to the area.
9
Ensure safety eye protection and protective clothing are worn when using this product.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Dispose of waste liquids in accordance with local with local authority regulations.
9
DO NOT use the pump to transfer solvents, (see application below).
8
DO NOT use the pump for any purpose other than for which it is designed.
8
DO NOT place the oil drum on an uneven surface, or in contact with any heat source.
8
DO NOT attempt to move the oil drum by pulling on the oil supply or the fluid transfer hose.
8
Keep the pump clean and store in a safe dry location when not in use.
9
2. INTRODUCTION
TP67: Self-priming pump with polypropylene body. Suitable for pumping gear-oil or other products with a similar viscosity. Includes 1.5m of hose
and universal adaptor.
Note: If the container you have will not accept direct mounting of Model No. TP67, order a Model No. TP67DT Trolley and a TP67/X Top Plate.
The pump fixes to the top plate which in turn mounts onto the trolley and avoids the need to connect the pump directly to the container.
TP67/X: Fixing Kit for EP80 Gear Oil Drums for use with Model No. TP67 Gear Oil Transfer Pump.
3. APPLICATIONS
Note: As a rule if the chemical you want to pump is delivered in a plastic container then you can use a plastic pump to transfer it. The
TP67 and TP67/X can not be used for the transfer of solvents. The unit will handle most disinfectants, detergents, pesticides,
degreasers, mild acids, alkalis, oils, weed-killers and chemical additives. If in doubt as to the suitability of use with a particular
substance contact your local Sealey supplier for advice.
4. ASSEMBLY
fig.1 TP67 Gear Oil Pump
© Jack Sealey Limited
GEAR OIL TRANSFER PUMP & FIXING KIT FOR
EP80 GEAR OIL DRUMS
TP67 & TP67/X
MODEL NO'S:
fig.2 TP67/X Adaptor kit
Original Language Version
PARTS LIST Refer to figs 1 & 2.
ITEM PART NO DESCRIPTION
1 TP67 Pump assembly
2 TP67.02 Hose assembly
3 TP67/03 2" BSP adaptor
4 TP67/04 Lock nut
5 TP67/05 Trisure adaptor
6 TP67/06 Multi-neck adaptor
7 TP67/07 Clamp pad
8 TP67/08 Clamping screw
9 TP67/X Washer
10 TP67X Lid (spinning)
TP67, TP67/X Issue:2 27/11/23