Timer Menu - Pool Controls Ozone Chemigem User Manual

Timer Menu

Setting the time
Once you have installed your Ozone Chemigem and turned it on, you will need to set the
correct time on the Chemigem 24-hour clock.
First, access the Menu System by pressing the ENT button.
The LCD will display the word TIMER MENU. Select this by pressing the ENT button once
more.
Line 2 on the LCD will now read SET TIME HOURS. Press ENT to select this option and
then use the Y/UP and N/DOWN buttons- to adjust the hours on the LCD. Confirm the
correct hours value by pressing ENT again.
The LCD will now show SET TIME MINUTES. Adjust the minutes using the Y/UP and
N/DOWN buttons. When complete, press ENT to return to normal operation.
ADJUST CYCLES Sub-Menu
Your Ozone Chemigem has two filter cycles pre-programmed as factory defaults as
follows:
Filter Cycle 1: ON at 07:00 (7am)
Filter Cycle 2: ON at 18:00 (6pm)
You can change the start and finish times of each filter cycle to meet your sanitiser
requirements and to suit your lifestyle.
To adjust filter cycle start and finish times, press ENT to access the Ozone Chemigem
Menu system. Press ENT again to select the TIMER menu and then scroll down using the
N/DOWN button until ADJUST CYCLES is displayed on the LCD.
Select this option by pressing ENT and the LCD will show the start (ON) time of the filter
cycle being adjusted. Use the Y/UP and N/DOWN buttons to adjust the start time. Press
ENT to confirm your selection and then the LCD will show the end (OFF) time for that filter
cycle. Adjust the OFF time in the same way as the ON time and press ENT to confirm.
After ON and OFF times for the first filter cycle have been adjusted, the ON time for the
second filter cycle is shown on the LCD. This can be adjusted in the same way, or if you
do not wish to make any changes, simply press ENT to confirm the time shown on the
LCD. Follow the same process to either adjust or confirm the OFF time for the second
filter cycle, and once this has been confirmed the LCD will display the home screen.
Note: an additional 2 filter cycles can be enabled and programmed via the Advanced
Settings Menu. For details on how to access this menu, please refer to the Advanced
Settings Manual (available to download from www.poolcontrols.com.au).
OFF at 10:00 (10am)
OFF at 21:00 (9pm)
Page 11