Table of Contents
Advertisement
Your trap is fitted to a Down the Line (left to right movement) base. It will have been supplied with a 200m wireless
radio control and receiver. Connect the radio receiver to the green six pin circular socket on the DTL control Box. The
notch in the radio receivers plug should face north as you push it into the socket and then screw the collar on to
secure the connection.
The main DTL control box is located at the rear of the DTL base, you will notice a time interrupter switch on the
control box; this switch has three positions.
1. Flicking the switch down will move the trap left to right. This feature is ideal if you do not have the remote with
you and want to move the traps direction, however please be aware that if you are not in control of the remote
another person may fire the trap.
2. When the switch is in a central position you can move the trap left to right via the remote control. You can press
the L-R movement button on the handset to nudge the trap in small increments, which is ideal if you are using
your trap on a tower. If you hold the L-R movement button for a period of 4 second (or individual presses in quick
succession amount to 4 seconds) the trap will continuously move left and right until disabled by pressing the
button again for 4 seconds. The traps movement will stop after 5 minutes if the trap is not fired.
3. When the switch is flicked upwards it will engage the time interrupter. This means that when the trap is fired, a
random sequence of movement (including pauses) will be initiated and last for 15 seconds.
Tilt
To tilt your trap left or right, to either level the flight of the clay or curl the flight of the clay, use the plastic hand
tension nut on the side of the trap which, is located underneath the main control box for the trap. Loosen the M10
nuts so that you can loosen or tighten the tension nut to the desired level of tilt and then re-tighten the m10 nuts to
secure.
Variations
Supermatch 6/8 DTL
09
Advertisement
Table of Contents
