Setup And Assembly; Shipping Contents; Tools Required For Assembly; Unpacking And Cleanup - Powermatic PM2244 Operating Instructions Manual

The specifications in this manual were current at time of publication, but because of our policy of continuous
improvement, Powermatic reserves the right to change specifications at any time and without prior notice,
without incurring obligations.

5.0 Setup and assembly

5.1 Shipping contents

See Figure 2.
1 Sander unit
1 Handwheel with handle – A
2 Extension tables – B
2 Infeed table brackets (L and R) – C
2 Outfeed table brackets (L and R) – D
2 Caster lock knobs (Pre-assembled onto stand)
– E
4 Leveling Feet (only for benchtop model)
16 Socket hd. cap screws M8x20 - HP1
16 Lock washers M8 - HP2
16 Flat washers M8 - HP3
Read and understand all
assembly instructions
assembly. Sander must be disconnected from
power during assembly procedures. Failure to
comply may cause serious injury.
Figure 2
before attempting

5.2 Tools required for assembly

Hex wrenches 4mm, 6mm
Open-end wrench 14mm
Straight edge (such as straight steel bar or carefully
jointed board)

5.3 Unpacking and cleanup

1. Inspect all contents for shipping damage.
Compare contents of shipping carton with the
contents list in this manual. Report any damage
or part shortages to your distributor.
assistant to help remove from pallet.
2. Remove any screws or blocks holding sander to
pallet. Carefully slide sander off pallet (NOTE:
There are internal blocks on the pallet securing
the sander – lift up on sander end to clear these
while sliding off pallet.)
7
Sander is heavy! Use an