Pulling Up The Bobbin Thread - Brother Innov-is 80 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
GETTING READY

Pulling up the bobbin thread

When making gathers or before free-motion quilting,
first pull up the bobbin thread as described below.
a Insert the bobbin into the bobbin case.
a
• Refer to steps through
bobbin" (page 26).
b Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.
c While lightly holding the upper thread with
your left hand with the needle in the up-
position, press (needle position button)
twice to lower and raise the needle.
1
a Needle position button
The bobbin thread is looped around the
upper thread and can be pulled up.
d Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
36
e
e
of "Installing the
f
Pull out about 10-15 cm (4-5 inches) of the
bobbin thread under the presser foot toward
the rear of the machine.
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover (A), and then lightly press down
on the right side (B).
A A
B