Advertisement
D
Cleaning bobbin case
2
3
4
Raise the needle to its
Slide the latch levers out
Remove the retaining ring.
highest position, pull the
from the retaining ring.
latch and remove the
bobbin case.
6
7
8
Remove any accumulated
Grasp the center post of
Insert the retaining ring
lint and thread with a
the hook, match the hook
with the notch up.
brush.
position opposite the driver
and insert.
CAUTION
Troubleshooting
∗Do not pull or push fabric while stitching.
1
It may bend the needle causing it to break.
∗Do not turn the balance wheel and pull the fabric by force when the thread is entangled or the motor is locked.
Remove the power plug
from the outlet.
If the thread is entangled, remove the thread and fabric according to the procedure below.
5
1
Remove the hook by
Open the hinged door and look for entangled
grasping the center post
thread.
and pulling out.
Note it's position related to
the driver.
9
3
Push the latch levers into
Turn the balance wheel to raise the needle,
their locked position.
then remove the fabric.
Replace the bobbin cace.
(See A.)
∗If machine runs but needle does not move, look to be sure bobbin winding shaft is moved to the left into the sewing position.
2
Cut the entangled thread with small scissors
above the needle plate and then gently
remove the thread and fabric.
4
Perform steps 1 through 8 of "Cleaning
bobbin case". (See D.)
***READ ME FIRST***
Should you encounter any problem with your product:
*DO NOT RETURN THIS PRODUCT TO THE STORE
*Please read the manual carefully. If you still need assistance, call
1-901-379-1010 for customer service.
*For the address of your closest service center, call 1-800-284-4357.
*KEEP ALL PACKING MATERIAL AND CARTON FOR FUTURE
TRANSPORT.
TO REPACK: FOLLOW DIAGRAM BELOW
=REPACKING=
1
2
3
4
5
6
XA8545-021
PRINTED IN CHINA
Advertisement
