Toro Flex-Force Power System 51834 Operator's Manual page 17

Adjusting the Cutting Swath
The trimmer comes from the factory with a cutting swath of 28 cm (11 inches) as shown in A of
to the following instructions to adjust the swath to 33 cm (13 inches) as shown in D of
1. Remove the swath blade from the guard by removing the 2 screws and 2 lock washers holding it in place
(B of Figure 13) and rotate the swath blade 180°.
2. Once the swath blade is rotated, install it onto the guard using the 2 screws and 2 lock washers previously
removed (C of Figure
Operating Tips
•
Keep the trimmer tilted toward the area being cut;
this is the best cutting area.
•
The string trimmer cuts when you move it from left
to right. This prevents the trimmer from throwing
debris at you.
•
Use the tip of the string to do the cutting; do not
force the string head into uncut grass.
•
Wire and picket fences can cause the string to
wear rapidly and even break. Stone and brick
walls, curbs, and wood can also cause the string
to wear rapidly.
•
Avoid trees and shrubs. The string can easily
damage tree bark, wood moldings, siding, and
fence posts.
13).
Figure 13
1. Direction of rotation
15
Figure 13. Refer
Figure 13.
Figure 14
2. String path
g333605
g333402