Haier HW80-B1239N User Manual page 23

EN
3UREOHP Cause
• Temperature sensor error.
)
• Heating error.
)
• Motor error.
)
• Water level sensor error.
)$
• Abnormal communication error.
)& )&
or or
)&
• 8QEDODQFHG ORDG HUURU
81%
 7URXEOHVKRRWLQJ ZLWKRXW GLVSOD\ FRGH
3UREOHP
Washing machine fails
to operate.
Washing machine
ZLOO QRW EH OOHG ZLWK
water.
Machine is draining
ZKLOH EHLQJ OOHG
Drainage failure.
Strong vibration while
spinning.
Operation stops
before completing
wash cycle.
Operation stops for
a period of time.
Cause
• Programme is not yet started.
• Door is not properly closed.
• Machine has not been switched on.
• Power failure.
• Child lock is activated.
• No water.
• Inlet hose is kinked.
• ,QOHW KRVH OWHU LV EORFNHG
• Water pressure is less than 0.03 MPa.
• Door is not properly closed.
• Water supply failure.
• Height of drain hose is below 80 cm.
• Drain hose end could reach into
water.
• Drain hose is blocked.
• 3XPS OWHU LV EORFNHG
• Drain hose end is higher than 100 cm
DERYH RRU OHYHO
• Not all transportation bolts have
been removed.
• Appliance has no solid position.
• Machine load is not correct.
• Water or electric failure.
• Appliance displays error code.
• Problem due to load pattern.
• Programme performs soaking cycle.
9-Troubleshooting
6ROXWLRQ
• Contact the After sales service.
• Contact the After sales service.
• Contact the After sales service.
• Contact the After sales service.
• Contact the After sales service.
• Check and balance laundry load in the drum.
6ROXWLRQ
• Check programme and start it.
• Close the door properly.
• Switch the machine on.
• Check power supply.
• Deactivate child lock.
• Check water tap.
• Check inlet hose.
• 8QEORFN LQOHW KRVH OWHU
• Check water pressure.
• Close the door properly.
• Ensure the water supply.
• Make sure that drain hose is
properly installed.
• Make sure the drain hose is not
in water.
• 8QEORFN GUDLQ KRVH
• &OHDQ SXPS OWHU
• Make sure that drain hose is
properly installed.
• Remove all transportation bolts.
• Ensure solid ground and a levelled
position.
• Check load weight and balance.
• Check power and water supply.
• Consider display codes.
• Reduce or adjust load.
• Cancel programme and restart.
23