Brother P-touch PT-1300 User Manual page 53

Number of digits (includ-
Protocol ing check digits and start
EAN128 4 through 22
CODABAR 4 through 22
UPC-E 6
UPC-A 13
EAN8 8
EAN13 13
I-2/5 Even number of digits*
* Two digits are needed to print each part of the data for an 1-2/5 barcode. Therefore, if
an odd number of digits are entered, "0" is automatically added at the beginning of the
data when the barcode is printed. However, "0" does not appear on the LCD display.
To use the barcode function:
1 Hold down
To change the data or parameters of a barcode that has already been cre-
ated, position the cursor below the barcode mark (
down
A label can only contain one barcode. If a barcode has already been
entered when
sage "1 BAR CODE / LABEL" will appear.
To quit the barcode function without making any changes, hold down
Code
2 Type in the new barcode data or edit the old data.
To change the barcode parameter settings:
Home
3 Press .
and stop codes)
N
and press
Code
Barcode
and pressing
Code
is held down and
Code
N
and press .
Barcode
Characters that
can be used
All ASCII charac-
ters
Numbers, letters,
and symbols –, $,
:, /, ., and +
Numbers
Numbers
Numbers
Numbers
Numbers
.
N
.
Barcode
N
Barcode
Notes
Start and stop
codes must be
A, B, C, or D
) before holding
is pressed, the error mes-
49